Conditions for Setting the DTC
B3205 00
The BCM has detected that the compatibility code stored in the driver window motor does not match the compatibility code stored in the BCM.
B3205 39
An internal malfunction has been detected by the BCM in the driver window motor while commanding the window UP or DOWN.
B3205 42
The BCM will automatically attempt to download the calibration program into the driver window motor (As will occur when the window motor has been replaced), if the first calibration program fails to load, the BCM will attempt to download the calibration program a second time. If this download fails, the BCM will set appropriate DTC.
B3205 4B
The BCM has detected that the driver window is not "normalized" and can set for the following reasons:
- When the battery has been disconnected
- When the battery has been replaced
- When the door wiring harness has been disconnected
- When the window motor has been disconnected.