LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Sunroof System >> Diagnostic Information and Procedures >> Power Sunroof Malfunction >> Circuit/System Testing

Circuit/System Testing

NOTE: Because of the accessibility of the switches, perform the switch component testing before beginning the circuit/system testing.
  1. Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the K61 Sunroof Control Module. It may take up to 2 minutes for all vehicle systems to power down.
  2. Test for less than 10 Ω between the ground circuit terminal 2 and ground.
    • If 10 Ω or greater 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • If less than 10 Ω 
  3. Verify a test lamp illuminates between the B+ circuit terminal 1 and ground.
    • If test lamp does not illuminate and the circuit fuse is good 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the B+ circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, verify the fuse is not open and there is voltage at the fuse.
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Ignition OFF.
    2. Test for infinite resistance between the B+ circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the K61 Sunroof Control Module.
    • If the test lamp illuminates 
  4. Ignition ON.
  5. Test for less than 1 V between the signal circuit terminals listed below and ground:
    • Terminal 3 - K61 Sunroof Control Module
    • Terminal 5 - K61 Sunroof Control Module
    • Terminal 6 - K61 Sunroof Control Module
    • If 1 V or greater 

      Repair the short to voltage on the signal circuit.

    • If less than 1 V 
  6. Ignition OFF.
  7. Test for infinite resistance between the signal circuit terminals listed below and ground:
    • Terminal 3 - K61 Sunroof Control Module
    • Terminal 5 - K61 Sunroof Control Module
    • Terminal 6 - K61 Sunroof Control Module
    • If less than infinite resistance 

      Repair the short to ground on the signal circuit

    • If infinite resistance 
  8. Disconnect the harness connector at the S72 Sunroof Switch and the S88 Sunroof Tilt Switch.
  9. Test for less than 5 Ω between the circuit terminals listed below:
    • S72 Sunroof Switch terminal 1 and K61 Sunroof Control Module terminal 3
    • S72 Sunroof Switch terminal 4 and K61 Sunroof Control Module terminal 5
    • S88 Sunroof Tilt Switch terminal 1 and K61 Sunroof Control Module terminal 3
    • S88 Sunroof Tilt Switch terminal 4 and K61 Sunroof Control Module terminal 6
    • If greater than 5 Ω 

      Repair the open/high resistance in the circuit.

    • If less than 5 Ω 
  10. Test or replace the K61 Sunroof Control Module.
scientia non olet · About LEMON Manuals