Circuit/System Testing

Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the S72 Sunroof Switch. It may take up to 2 minutes for all vehicle systems to power down.
Test for less than 10 Ω between the low reference circuit terminal 1 and ground.
- If 10 Ω or greater
1. Ignition OFF, disconnect the harness connector at the K61 Sunroof Control Module.
2. Test for less than 2 Ω in the low reference circuit end to end.
  - If 2 Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2 Ω, test or replace the K61 Sunroof Control Module.
- If less than 10 Ω
Ignition ON.
Verify the scan tool Slide Switch parameter is Short to Battery.
- If not Short to Battery
1. Ignition Off, disconnect the harness connector at the K61 Sunroof Control Module.
2. Test for infinite resistance between the signal circuit terminal 4 and ground.
- If less than infinite resistance, repair the short to ground on the circuit.
- If infinite resistance, replace the K61 Sunroof Control Module.
- If Short to Battery
Install a 5 A fused jumper wire between the signal circuit terminal 4 and the low reference circuit terminal 1.
Verify the scan tool Slide Switch parameter is Short to Ground.
- If not Short to Ground
1. Ignition OFF, disconnect the harness connector at the K61 Sunroof Control Module.
2. Test for less than 1 V between the signal circuit terminal 4 and ground.
  - If 1 V or greater, repair the short to voltage on the circuit.
  - If less than 1 V
3. Test for less than 2 Ω in the signal circuit end to end.
  - If 2 Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2 Ω, replace the K61 Sunroof Control Module.
- If Short to Ground
All OK.