Seat Adjuster Switch Test

Ignition OFF, disconnect the harness connector at the S64D Seat Adjuster Switch - Driver.
Test for infinite resistance between the B+ terminal D and each control terminal with the switch in the open position.
- If less than infinite resistance
  Replace the S64D Seat Adjuster Switch - Driver.
- If infinite resistance
Test for less than 2 Ω between the B+ terminal D and each control terminal with the appropriate switch in the closed position.
- If 2 Ω or greater
  Replace the S64D Seat Adjuster Switch - Driver.
- If less than 2 Ω
Test for less than 2 Ω between the ground terminal B and each control terminal with the switch in the open position.
- If 2 Ω or greater
  Replace the S64D Seat Adjuster Switch - Driver.
- If less than 2 Ω
All OK.