LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Seats >> Power Seat System >> Diagnostic Information and Procedures >> Power Seat Malfunction >> Circuit/System Testing >> Seat Adjuster Switch Circuit Test

Seat Adjuster Switch Circuit Test

  1. Ignition OFF, disconnect the harness connector at the S64D Seat Adjuster Switch - Driver.
  2. Test for less than 10 Ω between the ground circuit terminal B and ground.
    • If 10 Ω or greater 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • If less than 10 Ω 
  3. Ignition ON.
  4. Verify a test lamp illuminates between the B+ circuit terminal D and ground.
    • If the test lamp does not illuminate 
    1. Ignition OFF
    2. Test for infinite resistance between the B+ circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the B+ circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, verify the circuit breaker is not open and there is voltage at the circuit breaker.
    • If the test lamp illuminates 
  5. Test or replace the S64D Seat Adjuster Switch - Driver.
scientia non olet · About LEMON Manuals