LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumpers And Fascias >> Repair Instructions >> Front Bumper Impact Bar Replacement >> Installation Procedure

Installation Procedure

  1. Position the front bumper impact bar on the vehicle.
    Fig 1: Front Bumper Impact Bar
    GM2027927Courtesy of GENERAL MOTORS COMPANY
  2. Install the 8 front bumper impact bar bolts (1) and tighten to 100 N.m (74 lb ft).
    Fig 2: Front Bumper Impact Bar And Front Bumper Impact Bar Bolts
    GM2027923Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
    NOTE: Use only the original front bumper impact bar bolts. Replace bolts if damaged.
  3. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems .
  4. Install all related panels and components.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals