Rear Compartment Lid Latch
- Ignition OFF, disconnect the harness connector at the M40 Rear Compartment Lid Latch.
- Install a 10 A fused jumper wire between the control terminal 1 and 12 V. Install a jumper wire between the ground terminal 2 and ground.
- Verify the M40 Rear Compartment Lid Latch activates.
- If the M40 Rear Compartment Lid Latch does not activate.
Replace the M40 Rear Compartment Lid Latch.
- If the M40 Rear Compartment Lid Latch does activate.
- If the M40 Rear Compartment Lid Latch does not activate.
- All OK