Component Testing
- Ignition OFF, disconnect the X915 inline harness connector at the S58A Rear Compartment Lid Unlatch Switch-Exterior.
- Test for infinite resistance between the signal circuit terminal and ground circuit terminal listed below with the switch in the open position.
- Signal circuit terminal 7 and ground circuit terminal 2 (With UVC)
- Signal circuit terminal 4 and ground circuit terminal 3 (Without UVC)
- If less than infinite resistance
Replace the S58A Rear Compartment Lid Unlatch Switch-Exterior.
- If infinite resistance
- Test for less than 3 Ω between the signal circuit terminal and ground circuit terminal listed below with the switch in the closed position.
- Signal circuit terminal 7 and ground circuit terminal 2 (With UVC)
- Signal circuit terminal 4 and ground circuit terminal 3 (Without UVC)
- If 3 Ω or greater
Replace the S58A Rear Compartment Lid Unlatch Switch-Exterior.
- If less than 3 Ω
- All OK