LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> Diagnostic Information and Procedures >> Cruise Control Malfunction - DTC B3794, P0564, P0565, P0567, P0568, P056C, P0580, P0581, P155A-P155C or P162C >> Circuit/System Testing

Circuit/System Testing

NOTE:
  • An open ignition circuit or fuse before the control module will cause communication DTCs or power mode mismatch DTCs to set against or in the control module. This failure mode will be diagnosed in the no communications diagnostic procedure or power mode mismatch.
  • This test assumes the ignition circuit has a driver that will open under a high current condition before the fuse opens.
  • The driver can open under normal conditions such as battery run down protection or a retained accessory power mode.
  1. Ignition OFF, disconnect the harness connector at the S70L Steering Wheel Controls Switch-Left, ignition ON.
  2. Verify a test lamp illuminates between the ignition circuit terminal 1 and ground.
    • If the test lamp does not illuminate 
    1. Ignition OFF, disconnect the harness connector at the K9 Body Control Module.
    2. Test for greater than 100 Ω between the ignition circuit and ground.
      • If 100 Ω or less, repair the short to ground on the circuit.
      • If greater than 100 Ω
    3. Test for less than 2 Ω in the ignition circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, test or replace the K9 Body Control Module.
    • If the test lamp illuminates 
  3. Verify the scan tool ECM Cruise Control Switch Status parameter is Off.
    • If not Off 
    1. Ignition OFF, disconnect the harness connector at the K9 Body Control Module, ignition ON.
    2. Test for less than 1 V between the signal circuit terminal 3 and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the K9 Body Control Module.
    • If Off 
  4. Install a 3A fused jumper wire between the signal circuit terminal 3 and the ignition circuit terminal 1.
  5. Verify the scan tool ECM Cruise Control parameter is Disabled.
    • If not Error 
    1. Ignition OFF, disconnect the harness connector at the K9 Body Control Module.
    2. Test for infinite resistance between the signal circuit terminal 9 and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the signal circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K9 Body Control Module.
    • If Error 
  6. Test or replace the S70L Steering Wheel Controls Switch-Left.
scientia non olet · About LEMON Manuals