LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro Z/28 >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement (LS3, LSA) >> Installation Procedure

Installation Procedure

    Fig 1: Camshaft Position Sensor Assembly, Jumper Harness & Front Cover
    GM1484001Courtesy of GENERAL MOTORS COMPANY
  1. Reconnect the camshaft sensor (5) and the jumper harness (4).
  2. Install the O-ring (6) on the camshaft sensor assembly (4 and 5).
  3. Reconnect the camshaft position sensor assembly (4, 5 and 6) and the engine harness connector (3).
    4. NOTE:

    Before installing the camshaft sensor assembly, apply a small amount of clean motor oil to the O-ring (6).

  4. Install the camshaft position sensor assembly (4, 5 and 6) in the front cover (7).
    5. CAUTION:

    Refer to Fastener Caution .

  5. Install the camshaft position sensor mounting bolts and tighten to 10 N.m (89 lb in).
  6. Install the generator assembly. Refer to Generator Bracket Replacement (L99, LS3)Generator Bracket Replacement (LS7, LSA) .
scientia non olet · About LEMON Manuals