Component Testing
WARNING: This page is about a different variant/trim than selected.
NOTE:
The engine coolant temperature (ECT) sensor must be between 10-32°C (50-90°F) for an accurate measurement.
- Ignition OFF, disconnect the harness connector at the appropriate Q17 Fuel Injector.
- Test for 11-14 Ω between the terminals of the Q17 Fuel Injector.
- If not between 11-14 Ω
Replace the Q17 Fuel Injector.
- If between 11-14 Ω
- If not between 11-14 Ω
- Test for infinite resistance between each terminal and the injector housing/case.
- If not infinite resistance
Replace the Q17 Fuel Injector.
- If infinite resistance
- If not infinite resistance
- All OK.