Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Engine idling.
- Verify the parameters listed below do not display Malfunction with a scan tool:
- Cylinder 1-8 Injector Control Circuit High Voltage Test Status
- Cylinder 1-8 Injector Control Circuit Open Test Status
- Cylinder 1-8 Injector Control Circuit Low Voltage Test Status
- If Malfunction is displayed
Refer to Circuit/System Testing.
- If Malfunction is not displayed
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify DTC P0201, P0202, P0203, P0204, P0205, P0206, P0207 or P0208 does not set.
- If any of the DTCs set
Refer to Circuit/System Testing.
- If none of the DTCs set
- If any of the DTCs set
- All OK.