LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - DTC P0010 To DTC P0333) >> Diagnostic Information and Procedures >> DTC P0196, P0197, or P0198: Engine Oil Temperature (EOT) Sensor >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
NOTE:

Perform this verification procedure only if the ignition has been OFF for 10 hours or more.

  1. Ignition ON, observe the scan tool IAT Sensor, Engine Oil temperature Sensor, and ECT Sensor parameters. The readings should be within 15°C (27°F) of each other and also the ambient temperature.
  2. Operate the vehicle within the Conditions for Running the DTC to verify that the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.