Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P0133 , P0153, P015A, P015B, P015C or P015D

The ECM detects that the HO2S 1 rich-to-lean or lean-to-rich average response time is greater than a calibrated value.
The DTCs set within 100 s when the above condition is met.

P013A or P013C

The ECM detects that the accumulated mass air flow monitored during rich-to-lean transitions between 450-150 mV is greater than a calibrated value.

P013B or P013D

The ECM detects that the accumulated mass air flow monitored during lean-to-rich transitions between 350-650 mV is greater than a calibrated value.

P013E or P014A

The ECM detects that the O2 sensor voltage has not decreased below 450 mV within a calibrated value of accumulated air flow.

P013F or P014B

The ECM detects that the O2 sensor voltage has not increased above 350 mV within a calibrated value of accumulated air flow.

P2270 or P2272

The ECM does not detect a heated oxygen sensor voltage greater than 700 mV before accumulated mass air flow exceeds a calibrated value.

P2271 or P2273

The ECM does not detect a heated oxygen sensor voltage less than 100 mV before accumulated mass air flow exceeds a calibrated value.