Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0131, P0137, P0151, or P0157
- The ECM detects that the HO2S voltage is less than 50 mV.
- The DTCs set within 48 s when the above condition is met.
P0132, P0138, P0152, or P0158
- The ECM detects that the HO2S voltage is greater than 1,050 mV.
- The DTCs set within 13 s when the above condition is met.
P0134 or P0154
The ECM detects that the HO2S 1 voltage is between 350-550 mV for at least 50 s.
P0140 or P0160
The ECM detects that the HO2S 2 voltage is between 410-490 mV for at least 74 s.