LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - DTC P0010 To DTC P0333) >> Diagnostic Information and Procedures >> DTC P0097 or P0098: Intake Air Temperature (IAT) Sensor 2 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
NOTE:

You must perform the Circuit/System Verification before proceeding with Circuit/System Testing.

  1. Ignition OFF, and all vehicle systems OFF, it may take up to 2 min. for all vehicle systems to power down. Disconnect the harness connector at the IAT sensor 2.
  2. Test for less than 2 Ω between the low reference circuit terminal B and ground.
    • If 2 Ω or greater 
    1. Ignition OFF, disconnect the harness connector at the Engine Control Module.
    2. Test for less than 2 Ω in the low reference circuit end to end.
      • If 2 Ω or greater, repair the open or high resistance in the circuit.
      • If less than 2 Ω replace the Engine Control Module.
    • If less than 2 Ω 
  3. Ignition ON, test for 4.8-5.2 V between the intake air temperature signal 2 circuit terminal A and ground.
    • If less than 4.8 V 
    1. Ignition OFF, disconnect the harness connector at the Engine Control Module.
    2. Test for infinite resistance between the signal circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the signal circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the Engine Control Module.
    • If greater than 5.2 V 
      NOTE:

      If the signal circuit is shorted to a voltage the engine control module or the sensor may be damaged.

    1. Ignition OFF, disconnect the harness connector at the Engine Control Module.
    2. Ignition ON, test for less than 1 V between the signal circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the Engine Control Module.
    • If between 4.8-5.2 V 
  4. Ignition ON, verify the scan tool IAT sensor 2 parameter is colder than -39°C (-38°F).
    • If not colder than -39°C (-38°F). 

      Replace the Engine Control Module.

    • If colder than -39°C (-38°F). 
  5. Ignition OFF. Install a 3 A fused jumper wire between the signal circuit terminal A and the low reference circuit terminal B.
  6. Ignition ON. Verify the scan tool IAT sensor 2 parameter is warmer than 130°C (266°F).
    • If not warmer than 130°C (266°F). 

      Replace the Engine Control Module.

    • If warmer than 130°C (266°F). 
  7. Test or replace IAT sensor 2.
scientia non olet · About LEMON Manuals