Diagnostic Aids
WARNING: This page is about a different variant/trim than selected.
- Any condition that can cause the BARO or supercharger inlet pressure sensors to be shifted in value may cause this DTC to set.
- A resistance of 20-50 Ω on the 5 V reference terminal 1 or the low reference circuit terminal 2 may cause this DTC to set.
- The harness connectors for the BARO sensor and the supercharger inlet pressure sensor are of the same configuration but are not interchangeable. Review the engine controls schematics for the BARO sensor and the supercharger inlet pressure sensor and note the circuit colors. Inspect the wiring harnesses of both sensors for the proper connections.