Component Testing
WARNING: This page is about a different variant/trim than selected.
Static Test
- Ignition Off, disconnect the harness connector at the Q36 Supercharger Bypass Solenoid Valve.
- Test for 30-55 Ω between the control terminal 1 and the ignition terminal 2 of the valve.
- If not within 30-55 Ω
Replace the Q36 Supercharger Bypass Solenoid Valve.
- If within 30-55 Ω
- If not within 30-55 Ω
- All OK.
Dynamic Test
- Install a 10 A fused jumper wire between the ignition terminal 1 and 12 V. Install a jumper wire between the control terminal 2 and ground.
- Verify the Q36 Supercharger Bypass Solenoid Valve clicks.
- If the valve does not click
Replace the Q36 Supercharger Bypass Solenoid Valve.
- If the valve clicks
- If the valve does not click
- All OK