LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - DTC P0010 To DTC P0333) >> Diagnostic Information and Procedures >> DTC P0033: Supercharger Bypass Valve Solenoid >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Engine running.
  2. Verify a click is heard or felt from the Q36 Supercharger Bypass Solenoid Valve when commanding the Supercharger Bypass Solenoid Valve between 0-10 % with a scan tool.
    • If a click is not heard or felt  

      Refer to Circuit/System Testing

    • If a click is heard or felt 
  3. Verify the parameters listed below do not display Malfunction when commanding the Supercharger Bypass Solenoid Valve between 0-10 % with a scan tool:
    • Supercharger Bypass Solenoid Valve Control Circuit High Voltage Test Status
    • Supercharger Bypass Solenoid Valve Control Circuit Open Test Status
    • Supercharger Bypass Solenoid Valve Control Circuit Low Voltage Test Status
    • If Malfunction is displayed 

      Refer to Circuit/System Testing.

    • If Malfunction is not displayed 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  5. Verify a DTC does not set.
    • If a DTC sets 

      Refer to Circuit/System Testing

    • If a DTC does not set 
  6. All OK
scientia non olet · About LEMON Manuals