LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - DTC P0010 To DTC P0333) >> Diagnostic Information and Procedures >> DTC P0011: Camshaft Position System (L99) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition Off, remove the Q6 Camshaft Position Actuator Solenoid Valve.
  2. Verify the conditions listed below do not exist with the Q6 Camshaft Position Actuator Solenoid Valve:
    1. Torn, restricted, mis-positioned, or missing screens.
    2. Engine oil leak between the oil sealing lands of the solenoid. Inspect the lands of the solenoid for nicks.
    3. Oil seepage at the solenoid connector.
    • If a condition is found 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • If a condition is not found 
  3. Test or replace the Q6 Camshaft Position Actuator Solenoid Valve.

    Refer to Component Testing.

scientia non olet · About LEMON Manuals