LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls And Fuel - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions) >> Repair Instructions >> Throttle Body Assembly Replacement (Except LSA) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Throttle Body To Intake Manifold Retaining Bolts
    GM1950738Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW throttle body to intake manifold gasket (2). Align the locating tab of the gasket with the notch in the manifold.
  2. Install the throttle body (1) to the intake manifold.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the throttle body to intake manifold retaining bolts (3) and tighten to 10 N.m (89 lb in).
  4. Install the electrical wire harness connector from the throttle body.
  5. Install the outlet duct. Refer to Air Cleaner Resonator and Outlet Duct Replacement (L99, LS3) Air Cleaner Resonator and Outlet Duct Replacement (LS7) .
  6. Perform the throttle learn procedure. Refer to Q38 Throttle Body: Throttle/Idle Learn .
scientia non olet · About LEMON Manuals