Adding The Drained Fuel to The Fuel Tank for Method 1
WARNING: This page is about a different variant/trim than selected.
- Remove the J-45004 fuel tank drain hose (3) from the J-42960-2 fuel flapper door holder (2) .
- Remove the J-42960-2 fuel flapper door holder (2) from the fuel tank fuel filler pipe (1).
- Install the fuel filler hose (2) to the vehicle.
- Install the retaining hose clamp (3) to the fuel filler hose (2) and tighten to 4 N.m (35 lb in).
- Install the retaining hose clamp (1) to the fuel filler hose (2) and tighten to 4 N.m (35 lb in).
- Install the right rear wheel. Refer to Tire and Wheel Removal and Installation (Without RT2)Tire and Wheel Removal and Installation (With RT2) .
- Lower the vehicle to the ground. Refer to Lifting and Jacking the Vehicle .
- Add the drained fuel to the fuel tank.
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
WARNING:
Never drain or store fuel in an open container. Always use an approved fuel storage container in order to reduce the chance of fire or explosion.
CAUTION:
Refer to Fastener Caution .