Evaporative Emission Canister Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Evaporative Emission Canister & Fasteners

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Disconnect the evaporative emission pipes. Refer to Plastic Collar Quick Connect Fitting Service . Lower the rear suspension support. Refer to Rear Suspension Support Replacement .
1	Evaporative Emission Canister Fastener (Qty: 2)
2	Evaporative Emission Canister Procedure Disconnect the electrical connectors. Transfer parts as necessary.

Callout

Component Name

Preliminary Procedure

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Disconnect the evaporative emission pipes. Refer to Plastic Collar Quick Connect Fitting Service .
Lower the rear suspension support. Refer to Rear Suspension Support Replacement .

Evaporative Emission Canister Fastener (Qty: 2)

Evaporative Emission Canister

Procedure