Evaporative Emission Canister Purge Solenoid Valve Replacement (LS7)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Evaporative Emission Canister Purge Solenoid Valve (LS7)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement (Left Side)Intake Manifold Cover Replacement (Right Side) . Disconnect the quick disconnects. Refer to Plastic Collar Quick Connect Fitting Service .
1	Evaporative Emission Canister Purge Solenoid Valve Fastener CAUTION: Refer to Fastener Caution . Tighten 20 N.m (15 lb ft)
2	Evaporative Emission Canister Purge Solenoid Valve Procedure Disconnect the electrical connector.

Callout

Component Name

Preliminary Procedure

Evaporative Emission Canister Purge Solenoid Valve Fastener

CAUTION:

Tighten
20 N.m (15 lb ft)

Evaporative Emission Canister Purge Solenoid Valve
Procedure
Disconnect the electrical connector.