LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls And Fuel - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement (LS3, LSA) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Camshaft Position Sensor Assembly, Jumper Harness & Front Cover
    GM1484001Courtesy of GENERAL MOTORS COMPANY
  1. Remove the generator bracket assembly. Refer to Generator Bracket Replacement (L99, LS3)Generator Bracket Replacement (LS7, LSA) .
  2. Remove the camshaft position sensor mounting bolts (1).
  3. Remove the camshaft position sensor assembly (4, 5, 6) from the front cover (7).
  4. Disconnect the camshaft position sensor jumper harness (2) and the engine harness (3) electrical connectors.
  5. Remove the camshaft sensor assembly (4, 5, 6).
  6. Disconnect camshaft position sensor (5) from the jumper harness (4).
scientia non olet · About LEMON Manuals