Camshaft Position Sensor Replacement (L99)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Camshaft Position Sensor (L99)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the water pump. Refer to Water Pump Replacement (LS7, LS3/L99) Remove the generator bracket assembly. Refer to Generator Bracket Replacement (L99, LS3) .
1	Camshaft Position Sensor Fastener (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Position Sensor Procedure Disconnect the electrical connectors.

Callout

Component Name

Preliminary Procedures

Remove the water pump. Refer to Water Pump Replacement (LS7, LS3/L99)
Remove the generator bracket assembly. Refer to Generator Bracket Replacement (L99, LS3) .

Camshaft Position Sensor Fastener (Qty: 3)

CAUTION:

Tighten
10 N.m (89 lb in)

Camshaft Position Sensor
Procedure
Disconnect the electrical connectors.