Inspection/Maintenance (I/M) System DTC Table
WARNING: This page is about a different variant/trim than selected.
| System | DTCs Required to Set System Status to YES |
|---|---|
| If an inspection/maintenance system status indicator did NOT update to YES during the Inspection/Maintenance Complete System Set Procedure , review each indicator and reference this table to determine each DTC associated with the inspection/maintenance system status indicator. Each DTC listed below has specific conditions that must be met for the diagnostic to run. Included within the conditions are additional DTCs which, if set, may inhibit the DTCs listed below from running. Reviewing and operating the vehicle within the Conditions for Running for each DTC listed below will allow the inspection/maintenance system status indicators to transition to YES. | |
| Catalyst | DTC P0420 or P0430 |
| EGR/CMP | DTC P0011 (L99) |
| Evaporative Emission | |
| Fuel Systems | DTC P219A or P219B |
| Oxygen Sensor | |
| Oxygen Sensor Heater | DTC P0030-P0032, P0036-P0038, P0050-P0054, P0056-P0060, P0135, P0141, P0155, or P0161 |