Repair Verification
WARNING: This page is about a different variant/trim than selected.
- Install any components or connectors that have been removed or replaced during diagnosis.
- Perform any adjustment, programming, or setup procedures that are required when a component or module is removed or replaced.
- Clear the DTCs.
- Turn OFF the ignition for 60 s.
- Engine running, command each cylinder deactivation solenoid ON and OFF with a scan tool.
- Verify the follow parameters display OK or Not Run during each command.
- Cylinder 1, 4, 6, or 7 Deactivation Solenoid Valve Control Circuit High Voltage Test Status
- Cylinder 1, 4, 6, or 7 Deactivation Solenoid Valve Control Circuit Open Test Status
- Cylinder 1, 4, 6, or 7 Deactivation Solenoid Valve Control Circuit Low Voltage Test Status
- If any parameter displays Malfunction
Refer to Circuit/System Testing.
- If each parameter displays OK or Not Run
- Verify no DTCs are set.
- If any DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle and perform the appropriate diagnostic procedure.
- If no DTCs are set
- If any DTCs are set
- All OK.