LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - DTC P0335 To DTC P3449 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P2227: Barometric Pressure (BARO) Sensor >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Verify that DTC P2228, or P2229 is not set.
    • If none of the DTCs are set 
  2. Ignition On
  3. Verify the scan tool BARO parameter remains constant and is within the range specified in the Altitude Versus Barometric Pressure table.
    • If not constant or not within the specified range 

      Refer to Circuit/System Testing

    • If constant and within the specified range 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  5. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing

    • If the DTC does not set 
  6. All OK
scientia non olet · About LEMON Manuals