Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0030, P0050, P0053, P0059, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0116, P0117, P0118, P0120, P0122, P0123, P0128, P0131, P0132, P0133, P0134, P0135, P0151, P0152, P0153, P0154, P0155, P015A, P015B, P015C, P015D, P0178, P0179, P0201-P0208, P0220, P0222, P0223, P0300, P0301-P0308, P0442, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P1133, P1153, P1516, P2135, P2176, or P2269 are not set.
The intrusive diagnostics, device controls, engine overspeed protection, traction control, and reduced engine power are not active.
The engine is in closed loop status.
The system voltage is between 10-32 V for greater than 4 s.
The engine run time is greater than 10 s.
The engine coolant temperature (ECT) is warmer than -20°C (-4°F).
The engine speed is between 1,000-3,500 RPM.
The mass air flow is between 5-510 g/s.