Valve Rocker Arm Cover Removal - Right Side (LSA)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Ignition Coil, Bolt & Spark Plug Wire (Right Side)

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Do not remove the oil fill tube from the cover unless service is required. If the oil fill tube has been removed from the cover, the locking features of the tube will be damaged and no longer functional.

If the oil fill tube has been removed, install a NEW oil fill tube during assembly.

Remove the spark plug wires (3), as required.
Remove the ignition coil bolts (1) and ignition coils (2).

Fig 2: Identifying Valve Rocker Arm Cover

Courtesy of GENERAL MOTORS COMPANY

Remove the valve rocker arm cover bolts (1) and cover (2).
Remove and discard the valve rocker arm cover gasket, valve rocker arm cover grommets and valve rocker arm cover bolts if they are serviced with the grommet.

Fig 3: Identifying Cover Components (Right Side)

Courtesy of GENERAL MOTORS COMPANY

Remove the oil cap (1), oil fill tube (2) and seals (3, 4) from the cover, as required.