Valve Rocker Arm Cover Installation - Left Side (LS7)
WARNING: This page is about a different variant/trim than selected.
- All gasket surfaces should be free of oil or other foreign material during assembly.
- DO NOT use the valve rocker arm cover gasket again.
- Install NEW valve rocker arm cover grommets and use NEW valve rocker arm cover bolts if they are serviced with the grommet.
- Install a NEW gasket (504) into the valve rocker arm cover.
- Install the valve rocker arm cover (505) onto the cylinder head.
- Install the cover bolts (516) with grommets and tighten the valve rocker arm cover bolts to 12 N.m (106 lb in).
- Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the ignition coil bolts (723).
- Install the ignition coils (722), wire harness (721), and bolts (723) to the bracket (719). Tighten the ignition coil bolts to 10 N.m (89 lb in).
- Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the ignition coil bracket studs (720).
- Install the ignition coil and bracket assembly (719) and studs (720). Tighten the bracket studs to 12 N.m (106 lb in).
NOTE:
CAUTION:
Refer to Fastener Caution .