LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Intake Manifold Removal (LS3, L99, or LSA)

Intake Manifold Removal (LS3, L99, or LSA)

WARNING: This page is about a different variant/trim than selected.
    Fig 1: MAP Sensor, Grommet And Bolt
    GM1876003Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The intake manifold, throttle body, fuel injection rail, and fuel injectors may be removed as an assembly. If not servicing the individual components, remove the manifold as a complete assembly.

  1. Remove the manifold absolute pressure (MAP) sensor bolt (713).
  2. Remove the MAP sensor (714).
  3. Remove the seal (715) from the sensor, as required.
    4. Fig 2: Identifying Evaporative Emission Components
    GM1876004Courtesy of GENERAL MOTORS COMPANY
  4. Remove the evaporative emission (EVAP) clip (740), bolt (742), bracket (741), canister purge solenoid valve (730), and tubes (729 and 735).
    5. Fig 3: Positive Crankcase Ventilation (PCV) Hose
    GM1876005Courtesy of GENERAL MOTORS COMPANY
  5. Remove the positive crankcase ventilation (PCV) hose - dirty air (716).
    6. Fig 4: Identifying Intake Manifold Bolts & Fuel Rail Stop Brackets
    GM1876006Courtesy of GENERAL MOTORS COMPANY
  6. Remove the intake manifold bolts (512) and fuel rail stop brackets (712).
  7. Remove the intake manifold (500).
    8. Fig 5: Intake Manifold Gaskets
    GM1876007Courtesy of GENERAL MOTORS COMPANY
  8. Remove the intake manifold gaskets (514).
  9. Discard the intake manifold gaskets.
scientia non olet · About LEMON Manuals