LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Engine Front Cover Cleaning and Inspection (LS7)

Engine Front Cover Cleaning and Inspection (LS7)

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Front Cover Components
    GM1552459Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • Do not use the crankshaft oil seal again. Install a NEW crankshaft oil seal during assembly.
    • Do not use the front cover-to-engine block gasket again. Install a NEW gasket during assembly.
  1. Remove the crankshaft oil seal (140) from the front cover.
  2. Remove the camshaft position (CMP) sensor (703) and bolt (705).
  3. Remove the seal (704) from the sensor, if required.
  4. Clean the cover in solvent. Remove the sealant from the cover oil pan surface. Refer to Replacing Engine Gaskets .
    5. WARNING:

    Refer to Safety Glasses Warning .

  5. Dry the cover with compressed air.
  6. Inspect the gasket sealing surfaces for excessive scratches or gouging.
  7. Inspect the threaded bolt holes for damaged threads or debris.
  8. Inspect the crankshaft oil seal and CMP sensor bore for damage.
scientia non olet · About LEMON Manuals