LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Engine Front Cover Cleaning and Inspection (LS3 or LSA)

Engine Front Cover Cleaning and Inspection (LS3 or LSA)

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Front Cover, Oil Seal, Camshaft Position Sensor, Bracket & O Ring
    GM1704625Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • Do not use the crankshaft oil seal again. Install a NEW crankshaft oil seal during assembly.
    • Do not use the front cover-to-engine block gasket again. Install a NEW gasket during assembly.
  1. Remove the crankshaft oil seal (4) from the front cover.
  2. Clean the cover in solvent. Remove the sealant from the cover oil pan surface. Refer to Replacing Engine Gaskets .
    3. WARNING:

    Refer to Safety Glasses Warning .

  3. Dry the cover with compressed air.
  4. Inspect the gasket sealing surfaces for excessive scratches or gouging.
  5. Inspect the threaded bolt holes for damaged threads or debris.
  6. Inspect the crankshaft oil seal and camshaft position (CMP) sensor mounting bores for damage.
scientia non olet · About LEMON Manuals