LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Engine Coolant Air Bleed Pipe and Hole Cover Cleaning and Inspection (LS3, L99, or LSA)

Engine Coolant Air Bleed Pipe and Hole Cover Cleaning and Inspection (LS3, L99, or LSA)

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Coolant Air Bleed Pipe Seal
    GM1552485Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do not use the engine coolant air bleed pipe seals again. Upon installation of the pipe, install NEW seals.

  1. Remove the seals (308) from the pipe.
    2. Fig 2: Coolant Air Bleed Pipe
    GM1552473Courtesy of GENERAL MOTORS COMPANY
  2. Clean the pipe in solvent.
    3. WARNING:

    Refer to Safety Glasses and Compressed Air Warning .

  3. Dry the pipe with compressed air.
  4. Inspect the pipe for damaged sealing surfaces (1, 2) or restrictions within the pipe (3).
scientia non olet · About LEMON Manuals