LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Engine Block Valley Cover Installation (LS3, LSA, or LS7)

Engine Block Valley Cover Installation (LS3, LSA, or LS7)

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Valley Cover Seals & Gasket
    GM1552536Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    All gasket surfaces should be free of oil or other foreign material during assembly.

  1. Lubricate the O-ring seals (537) with clean engine oil.
  2. Install the O-ring seals (537) to the cover.
    3. Fig 2: View Of Cover, Gasket, And Bolts
    GM1559897Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the cover (555), gasket (556), and bolts (506). Tighten the cover bolts to 25 N.m (18 lb ft).
    4. Fig 3: Oil Pressure Sensor & Washer
    GM1408864Courtesy of GENERAL MOTORS COMPANY
  4. Apply sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent, to the threads of the sensor.
  5. Install the oil pressure sensor (706) and sealing washer (707). Tighten the sensor to 35 N.m (26 lb ft).
scientia non olet · About LEMON Manuals