LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Cylinder Head Removal - Right Side

Cylinder Head Removal - Right Side

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Right Cylinder Head & Bolts
    GM1408870Courtesy of GENERAL MOTORS COMPANY
  1. If camshaft lobe lift measurement is required, perform measurement prior to removal of the cylinder heads. Refer to Camshaft and Bearings Cleaning and Inspection (without variable valve timing) Camshaft and Bearings Cleaning and Inspection (with variable valve timing) .
    2. NOTE:

    The cylinder head bolts are of a torque-to-yield design and are NOT to be used again. Install NEW cylinder head bolts during assembly.

  2. Remove the cylinder head bolts (220, 221).
    3. CAUTION:

    After removal, place the cylinder head on 2 wood blocks in order to prevent damage to the sealing surfaces.

  3. Remove the cylinder head (218).
    4. Fig 2: Cylinder Head Gasket & Locating Pins - Right
    GM1408871Courtesy of GENERAL MOTORS COMPANY
  4. Remove the gasket (217) and locating pins (230).
  5. Discard the gasket and cylinder head bolts.
scientia non olet · About LEMON Manuals