LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Camshaft Removal (LS7)

Camshaft Removal (LS7)

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Camshaft Retainer & Bolts
    GM1552492Courtesy of GENERAL MOTORS COMPANY
  1. Remove the camshaft retainer bolts (204) and retainer (203).
    2. Fig 2: Camshaft Installation
    GM1552493Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft bearings.

  2. Remove the camshaft.
    1. Install the 3 M8-1.25 x 100 mm bolts into the camshaft front bolt holes.
    2. Using the bolts as a handle, carefully rotate and pull the camshaft out of the engine block.
    3. Remove the bolts from the front of the camshaft.
scientia non olet · About LEMON Manuals