LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Oil Level Indicator Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Level Indicator Tube
    GM651879Courtesy of GENERAL MOTORS COMPANY
  1. Lubricate the O-ring seal with clean engine oil.
  2. Install the oil level indicator tube into position.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Insert the oil level indicator tube into the engine block until the collar is flush with the block.
  5. Lower the vehicle.
    6. CAUTION:

    Refer to Fastener Caution .

  6. Install the oil level indicator tube bolt and tighten to 25 N.m (18 lb ft).
    7. Fig 2: Oil Level Indicator
    GM651880Courtesy of GENERAL MOTORS COMPANY
  7. Install the oil level indicator.
  8. Check the oil level and add if necessary.
scientia non olet · About LEMON Manuals