LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Support Fixture (L99, LSA, LS3) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Loosen and remove the J 28467-7A  lift hooks.
    2. Fig 1: Main Bar
    GM2210887Courtesy of GENERAL MOTORS COMPANY
  2. Remove the J 28467-81  kit (1).
  3. Remove J 36857-1  Lifting Hook from the right cylinder head.
  4. Remove J 4179-2  engine bracket from the left cylinder head.
  5. Install the #4 ignition coil to the right valve cover.
  6. Install the ground wire bolt to the right cylinder head.
  7. Install the two studs to the left valve cover ignition coil bracket.
  8. Install the hood support strut. Refer to Hood Strut Replacement .
  9. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About LEMON Manuals