Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Replace the valve lifter oil filter. Refer to Valve Lifter Oil Filter Replacement .
- If installing the old sensor, apply threadlocker sealant. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.
- Using the J 41712 oil pressure sensor socket (1), install the oil pressure sensor/switch. Tighten the engine oil pressure sensor to 35 N.m (26 lb ft).
- Reconnect the oil pressure sensor/switch electrical connector (2).
- Install the vacuum hose for the power brake booster.
- Install the intake manifold covers. Refer to Intake Manifold Cover Replacement (Left Side) Intake Manifold Cover Replacement (Right Side) .
CAUTION:
Refer to Component Fastener Tightening Caution .