LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Oil Pressure Sensor and/or Switch Replacement (L99, LS3) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Vacuum Booster Hose
    GM63936Courtesy of GENERAL MOTORS COMPANY
  1. Remove the engine cover. Refer to Engine Cover Replacement .
  2. Clean area around the oil sensor/switch before removing it.
  3. Remove the positive crankcase ventilation hose/pipe/tube. Refer to Positive Crankcase Ventilation Hose/Pipe/Tube Replacement (Dirty Air - L99, LS3, LSA) Positive Crankcase Ventilation Hose/Pipe/Tube Replacement (Clean Air - L99, LS3, LSA) .
    4. Fig 2: Oil Pressure Sensor/Switch Electrical Connector & Engine Wiring Harness Ground Strap
    GM1656451Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the electrical connector for the oil pressure sensor/switch (2).
    5. Fig 3: Servicing Oil Pressure Sensor/Switch
    GM1658870Courtesy of GENERAL MOTORS COMPANY
  5. Using the J 41712  oil pressure sensor socket (1) , remove the oil pressure sensor/switch.
scientia non olet · About LEMON Manuals