LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Oil Pressure Sensor and/or Switch Replacement (L99, LS3) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Replace the valve lifter oil filter. Refer to Valve Lifter Oil Filter Replacement .
    2. Fig 1: Servicing Oil Pressure Sensor/Switch
    GM1658870Courtesy of GENERAL MOTORS COMPANY
  2. If installing the old sensor, apply threadlocker sealant. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Using the J 41712  oil pressure sensor socket (1), install the oil pressure sensor/switch. Tighten the engine oil pressure sensor to 35 N.m (26 lb ft).
    4. Fig 2: Oil Pressure Sensor/Switch Electrical Connector & Engine Wiring Harness Ground Strap
    GM1656451Courtesy of GENERAL MOTORS COMPANY
  4. Reconnect the oil pressure sensor/switch electrical connector (2).
    5. Fig 3: Identifying Vacuum Booster Hose
    GM63936Courtesy of GENERAL MOTORS COMPANY
  5. Install the vacuum hose for the power brake booster.
  6. Install the left engine sight cover.
scientia non olet · About LEMON Manuals