LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Front Cover Replacement (LS3, LSA) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Electrical Connector, Cable Channel Bolt & Pin
    GM1697734Courtesy of GENERAL MOTORS COMPANY
  1. Remove the water pump. Refer to Water Pump Replacement (LS7, LS3/L99)Water Pump Replacement (LSA) .
  2. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement (L99, LS3, LSA) .
  3. Disconnect the engine harness electrical connector (1) from the camshaft position (CMP) sensor wire harness electrical connector.
    4. Fig 2: View Of Oil Pan-To-Front Cover Bolts
    GM832976Courtesy of GENERAL MOTORS COMPANY
  4. Remove the oil pan-to-front cover bolts (1).
    5. Fig 3: View Of Front Cover & Gasket
    GM1704624Courtesy of GENERAL MOTORS COMPANY
  5. Remove the front cover bolts (1).
  6. Remove the front cover (2) and gasket (3).
  7. Discard the front cover gasket.
    8. Fig 4: View Of Front Cover, Oil Seal, Camshaft Position Sensor, Bracket & O Ring
    GM1704625Courtesy of GENERAL MOTORS COMPANY
  8. Remove the crankshaft front oil seal (4).
  9. If replacing the engine front cover perform the following steps, otherwise proceed to step 8 of the installation procedure.
  10. Remove the CMP sensor wire harness bolts (1 and 6).
  11. Disconnect the CMP sensor wire harness from the CMP sensor.
  12. Remove the CMP sensor wire harness (5).
  13. Remove the CMP sensor (2).
scientia non olet · About LEMON Manuals