LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Block Valley Cover Replacement (LS3, LS7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Valley Cover, Retaining Bolts, Gasket & O-Rings
    GM1468311Courtesy of GENERAL MOTORS COMPANY
  1. Install the O-rings (4) to the engine valley cover (2).
  2. Install the engine valley gasket (3).
  3. Install the engine valley cover (2).
  4. Install the retaining bolts (1).
    5. CAUTION:

    Refer to Fastener Caution .

  5. Tighten the engine valley retaining bolts to 25 N.m (18 lb ft).
  6. Install the oil pressure switch. Refer to Engine Oil Pressure Sensor and/or Switch Replacement (L99, LS3) Engine Oil Pressure Sensor and/or Switch Replacement (LS7) .
  7. Install the intake manifold. Refer to Intake Manifold Replacement (LS3, LS7, LSA) Intake Manifold Replacement (LS7) .
scientia non olet · About LEMON Manuals