LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Housing Replacement >> Installation Procedure - Cover without Seal

Installation Procedure - Cover without Seal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Rear Oil Seal Housing Components
    GM2100849Courtesy of GENERAL MOTORS COMPANY
  1. Position a NEW rear oil seal housing gasket (3) and the housing (2) to the engine.
  2. Install the rear oil seal housing bolts (1) until snug. Do not overtighten.
  3. Rotate the crankshaft until 2 opposing flywheel bolts holes are parallel to the oil pan surface.
    4. Fig 2: Cover Alignment Tool
    GM451716Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The tapered legs of the alignment tool must enter the rear cover oil seal bore.

  4. Install the J 41476  front and rear cover alignment tool and bolts onto the rear of the crankshaft.
  5. Tighten the J 41476  front and rear cover alignment tool bolts until snug. Do not overtighten.
    6. Fig 3: View Of Oil Pan-To-Rear Cover Bolts
    GM680413Courtesy of GENERAL MOTORS COMPANY
  6. Install the oil pan to rear oil seal housing bolts (1).
    1. Tighten the oil pan to rear cover bolts to 12 N.m (106 lb in).
    2. Tighten the rear oil seal housing to engine bolts to 30 N.m (22 lb ft).
  7. Remove the J 41476  front and rear cover alignment tool.
  8. Install a NEW crankshaft rear oil seal. Refer to Crankshaft Rear Oil Seal Replacement .
  9. If equipped with automatic transmission, install the automatic transmission flex plate. refer to Automatic Transmission Flex Plate Replacement .
  10. If equipped with manual transmission, install the flywheel. Refer to Engine Flywheel Replacement .
scientia non olet · About LEMON Manuals