LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Housing Replacement >> Installation Procedure - Cover with Seal

Installation Procedure - Cover with Seal

WARNING: This page is about a different variant/trim than selected.
  1. Install the J 41479-2A  crankshaft rear oil seal installation guide cone and bolts onto the rear of the crankshaft.
    2. Fig 1: Identifying Rear Housing Components
    GM2100848Courtesy of GENERAL MOTORS COMPANY
  2. Install the NEW rear housing gasket (1), rear housing with seal (2), rear housing to engine bolts (3) and oil pan to rear housing bolts (4).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Tighten the rear housing to engine bolts (3) until snug. Do not overtighten. Tighten the oil pan-to-rear housing bolts (4) to 12 N.m (106 lb in).
  4. Tighten the rear housing to engine bolts (3) to 30 N.m (22 lb ft).
  5. Remove the J 41479-2A  crankshaft rear oil seal installation guide.
  6. If equipped with automatic transmission, install the automatic transmission flex plate. refer to Automatic Transmission Flex Plate Replacement .
  7. If equipped with manual transmission, install the flywheel. Refer to Engine Flywheel Replacement .
scientia non olet · About LEMON Manuals