LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Camshaft Replacement (L99) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Flywheel Holder
    GM1658136Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    If camshaft replacement is required, the valve lifters must also be replaced.

  1. Remove the radiator support. Refer to Air Conditioning Condenser Replacement (LSA LS3, L99) .
  2. Remove the valve lifters. Refer to Valve Lifter Replacement (Without AFM) Valve Lifter Replacement (With AFM) .
  3. Remove the oil pump, screen, and crankshaft oil deflector. Refer to Oil Pump, Screen, and Crankshaft Oil Deflector Replacement (L99, LS3,LSA) .
  4. Remove the camshaft position actuator. Refer to Camshaft Position Actuator Replacement .
    5. Fig 2: Camshaft Retainer & Bolts
    GM1552492Courtesy of GENERAL MOTORS COMPANY
  5. Remove the camshaft retainer bolts (204) and retainer (203).
  6. Install the camshaft sprocket bolt into the camshaft front bolt hole
  7. Using the bolt as a handle, carefully rotate and remove the camshaft from the engine block.
  8. Remove the bolt from the camshaft.
scientia non olet · About LEMON Manuals