LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Flex Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Flywheel & Bolts
    GM832979Courtesy of GENERAL MOTORS COMPANY
  1. Remove the automatic transmission. Refer to Transmission Replacement .
    2. NOTE:

    Note the position and direction of the flex plate before removal. The flex plate does not use a locating pin for alignment. Mark or scribe the end of the crankshaft and the flex plate before component removal.

  2. Remove the automatic transmission flex plate bolts.
  3. Remove the flex plate.
    4. Fig 2: View Of Bolts & Spacer
    GM642281Courtesy of GENERAL MOTORS COMPANY
  4. Install two M11x1.5 mm bolts (1) to the threaded holes of the spacer, if applicable.
  5. Rotate the bolts clockwise to remove the spacer.
    6. Fig 3: View Of Spacer & Crankshaft Rear
    GM642276Courtesy of GENERAL MOTORS COMPANY
  6. Remove the spacer from the rear of the crankshaft, if applicable.
scientia non olet · About LEMON Manuals